Nidec MCE Motion 4000 - Typical Speed Profile Settings; Verify One-Floor-Run Operation

Final Adjustments
3-12 Manual # 42-02-2M01 A1
Typical Speed Profile Settings
Verify One-Floor-Run Operation
1. Run the elevator on Inspection between landings and verify that it moves properly.
2. After taking the elevator out of inspection mode, verify that the elevator corrects to a
landing and stops properly.
3. Make a one floor run and observe the elevator as it moves between landings and stops at
landings.
4. Follow procedure in Adjust for Response if necessary.
5. Follow procedure in Adjust Control Gains, Adjust Load Cell Compensation, and
Adjust Inertia Compensation as required
Table 3.3 Speed Profile Settings Per Rated Speed
Params
25 FPM
or Less
(26-75)
FPM
(76-100)
FPM
(101-
199) FPM
(200-
249) FPM
(250-
349) FPM
350FPM
or greater
Standard Jerk (165)
Alt Start Jerk (179)
0.10 0.15 1.5 3.0 3.0 4.0 4.0
Standard Roll Jerk (166)
Alt Roll Jerk (180)
0.10 0.15 1.5 3.0 3.0 4.0 4.0
Standard Stop Jerk (167)
Alt Stop Jerk (181)
0.10 0.15 1.5 2.5 2.5 2.5 2.5
Standard Accel. (168)
Alt Accel (182)
0.10 0.25 0.5 1.75 2.5 2.75 3.0
Standard Decel. (169)
Alt Decel. (183)
0.10 0.25 0.5 1.25 1.5 1.75 2.0
Man Start Jerk (170) 0.10 0.15 0.50 1.00 1.00 1.00 1.00
Man Roll Jerk (171) 0.10 0.15 0.50 1.00 1.00 1.00 1.00
Man Stop Jerk (172) 0.10 0.15 0.50 1.00 1.00 1.00 1.00
Man Accel. (173) 0.10 0.25 0.50 0.50 0.50 0.50 0.50
Man Decel. (174) 0.10 0.25 0.50 0.50 0.50 0.50 0.50
Danger start Jerk (175) 5.0 10.0 Auto Calc Auto Calc Auto Calc Auto Calc Auto Calc
Danger Roll Jerk (176) 2.0 2.0 Auto Calc Auto Calc Auto Calc Auto Calc Auto Calc
Danger Stop Jerk (177) 1.0 2.0 Auto Calc Auto Calc Auto Calc Auto Calc Auto Calc
Danger Decel. (178) 0.25 0.75 Auto Calc Auto Calc Auto Calc Auto Calc Auto Calc
Standard Slew slope (142) 0.15 0.15 0.25 0.5 0.5 0.5 0.5