F8: Software Revision
42-02-2M01 A1 4-139
4
Motion 4000
F8: Software Revision
Displays current software level for each of the controllers processors.
•PTHC D
VER # T08.01-0042
The “boot loader” IC polls each processor as the controller is powering up, ensuring that each
has the right software. The software version for the boot loader itself is displayed in a scrolling
message as the controller is powering up.
Status Displays
To access Status Displays:
• Place switch F8 in the up position (all others down).
• Press N to cycle through available status displays.
The following status displays are available:
• Software Version - Main processor software version num-
ber.
• Eligibility Map - Door access for each floor (F = front, R = rear, B = both). Read left to
right:
• Floors 1 through 16 in the top row
• Floors 17 through 32 in the bottom row
Please refer to “CAR SERVES FRNT/FLR 1? (simplex)/THIS CAR SERVES FRNT/FLR 1?
(duplex)” on page 4-14 for programming instructions.
• Current Load - Load in the car as a percentage of full load (analog load weigher required).
F1 & F8: Board Software Versions
When both F1 and F8 switches are up, board software version numbers are visible. This can be
helpful when troubleshooting with an MCE technician.
• Press N button for versions:
• MPUA: MPU board software
• CTLA: Control board A processor software
• CTLB: Control board B processor software
• CTLC: Control board C processor software
• MPIA: Motion Processor board A processor software
• MPIB: Motion Processor board B processor software
• MPIC: Motion Processor board C processor software
• UIO(0 - n): UIO board software
• CHP: CHP board software
• RDR-A: Brake processor A software
• RDR-B: Brake processor B software
• CPI-2: Car panel interface processor software
• COP-2: Car panel interface processor software
• SC-3HN Riser processor software
To Next Page
Loading...
