2 Safety
BU 0210 en-3117 11
2 Safety
Pos: 26 /A nl eitu nge n/El ektr oni k/P OSIC ON /2. Sich erh eit /Bes ti mmung sg em äße V er wen dung [PO SIC ON] @ 14\mod_1479994530918_388.docx @ 2308242 @ 2 @ 1
2.1 Intended use
The POSICON technology function from Getriebebau NORD GmbH & Co. KG is a software-assisted
functional extension for frequency inverters manufactured by NORD. It forms an integral part of the
frequency inverter and cannot be used without this. Because of this, all of the specific safety
information for the relevant frequency inverter contained in the relevant manual ( Section 9.2
"Documents and software") apply without restriction.
The POSICON technology function is essentially used as a solution for complex drive applications with
positioning functions which are implemented using frequency inverters manufactured by NORD.
Pos: 28 /A nl eitu nge n/El ek tro nik/ POSI CON/ 2. Sich erheit /Aus wahl u nd Qualifi kati on des P erson als [PO SICON ] @ 14\mod_1479994531376_388.docx @ 2308278 @ 233 @ 1
2.2 Selection and qualification of personnel
The POSICON technology function may only be commissioned by qualified electricians. These must
have the necessary knowledge of the technology functions and the electronic drive technology and the
configuration aids which (e.g. NORD CON software) which are used, as well as the peripherals
(including the controller) which are used in association with the drive application.
In addition, the qualified electricians must also be familiar with the installation, commissioning and
operation of the sensors and electronic drive technology, as well as all of the accident prevention
regulations, guidelines and laws which apply at the place of use.
2.2.1 Qualified personnel
Qualified personnel includes persons who due to their specialist training and experience have
sufficient knowledge in a specialised area and are familiar with the relevant occupational safety and
accident prevention regulations as well as the generally recognised technical rules.
These persons must be authorised to carry out the necessary work by the operator of the system.
2.2.2 Qualified electrician
An electrician is a person who, because of their technical training and experience, has sufficient
knowledge with regard to
• Switching on, switching off, isolating, earthing and marking power circuits and devices,
• Proper maintenance and use of protective devices in accordance with defined safety standards.
• Emergency treatment of injured persons.
Pos: 29 /A llg em ein/ Allg em eing ülti ge M od ule/ ---------Seite numbruc h kom pakt --------- @ 13\ mod_1476369695906_0.docx @ 2265495 @ @ 1
To Next Page
Loading...
Need help?
General
