Nord Drivesystems SK 200E Series - 6 Parameters; Description of Parameters; Figure 6: Explanation of Parameter Description

6 Parameters
BU 0210 en-3117 59
6 Parameters
The following only lists the specific parameters and display and setting options for the POSICON
technology function. For a detailed overview of all available parameters, please refer to the frequency
inverter manual (BU0200 / BU0250).
Pos: 20 3 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ Allg emei n/Par ameter beschr eib ung_0 1 [SK 1x xE, SK 2xx E, SK 2x xE-FDS, P OSICON , S afety ] @ 9\mod_1447147899292_388.docx @ 261908 @ 2 @ 1
6.1 Description of parameters
Pos: 20 4 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ Allg emei n/Par ameter beschr eib ung_0 2 [SK 1x5 E, SK 1x xE-FDS, P OSIC ON, S afety ] - ne ue Dars tellu ngsvar iant e @ 9\mod_1446537266668_388.docx @ 260250 @ @ 1
P000 (parameter number) Operating display (parameter name) xx
1)
S P
Setting range
(or display range)
Display of typical display format (e.g. (bin =
binary)) of possible setting range and number
of decimal places
Other applicable
parameter(s):
List of other parameters that
are directly associated
Arrays
[-01]
If parameters have a substructure in several arrays, this is shown here.
Factory setting
{ 0 }
Default setting that the parameters typically have in the as-delivered condition of the device or to
which it is set after carrying out "Restore factory settings" (see parameter P523).
Scope of Application
List of device variants to which this parameter applies. If the parameter is generally valid, i.e. for the entire
model series, this line is omitted.
Description
Description, functionality, meaning and the like for this parameter.
Note
Additional notes about this parameter
Setting values
(and display values)
List of possible settings with description of the respective functions
1)
xx = other identification
Figure 6: Explanation of parameter description
Information
Description of parameters
Unused lines of information are not listed.
Pos: 20 5 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ Allg emei n/Par ameter beschr eib ung_0 3 [POSI CON, S afety ] @ 14\mod_1479133032600_388.docx @ 2304028 @ @ 1
Note / Explanation:
Code Designation Meaning
S
Supervisor-Parameter
The parameter can now be displayed and modified if the
relevant supervisor code has been set (see parameter
P003).
P
Parameter set-dependent
The parameter provides different setting options that are
dependent upon the selected parameter set.
Pos: 20 6 /Allg emein/ Allg emeing ültig e Mod ule/---------Sei tenumbr uch ko mpakt --------- @ 13\mod_1476369695906_0.docx @ 2265495 @ @ 1