Installation
3-35
Part 1107600_03
2014 Nordson Corporation
To set up a digital input
Set up the parameter control option for each input that you connected to the
melter. Table 3‐8 lists the available control options. Refer to Setting Up the
Melter earlier in this section, for information about how to select operating
parameters and edit parameter control options.
With the exception of the pump
enable/disable control option, all inputs
are transition‐based.
Input Setup in Appendix B
Table 3‐8 Digital Input Data
Input Terminals Operating Parameter Control Option Note
5 11 and 12 34
0 - Input Disabled (default)
1 - Standby On/Off
2 - Heaters On/Off
3 - Motor 1 Enable/Disable
4 - Hose/Gun 1 Enable/Disable
5 - Hose/Gun 2 Enable/Disable
6 - Hose/Gun 3 Enable/Disable
7 - Hose/Gun 4 Enable/Disable
8 - Hose/Gun 5 Enable/Disable
9 - Hose/Gun 6 Enable/Disable
A
6 13 and 14 35
7 15 and 16 36
8 17 and 18 37
9 19 and 20 38
10 9 and 10 39
NOTE A: If control option 3 is selected, the motor will not turn on—even if you press the pump key—if voltage is not present on
the input’s contacts.
To Next Page
Loading...
