Nordson Asymtek X-1010 User Manual

Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 4-122 P/N 196515 (Revision A)
Go to Scale
Communications
Verification
Connect the Power Cable
to the facility outlet and
switch Main Circuit Breaker
to ON (I) position,
Did the Scale initialize?
Press the green ON (I) button on
the Operator’s Console, and
enter FmNT.
No
A
Locate and observe the green
LED on the Scale Control
Module.
Is the green LED
illuminated?
In the FmNT Main Window,
click Configuration and select
Setup Scale.
Go to Scale Power
Verification
Yes No
In the FmNT Scale Setup
Window, Scale Operations tab,
observe the weight displayed
next to Current Reading.
Remove the Scale Cup.
Did the weight
displayed in the Scale
Setup Window
change?
Click the Zero Scale button.
Did the reading
change to and stabilize
at 0.00?
On the Setup Scale D104 tab,
adjust the Filter and/or Stability
settings. (Refer to FmNT User
Guide or FmNT Online Help.)
Stop! Scale Operation is
not
root cause of fault.
Was the error
corrected?
No
Repeat steps indicated above
before proceeding.
Stop here. Filter/Stability is
root cause of Scale fault
Contact Asymtek
Technical Support
Yes No
Yes
Yes
Yes
No
Go to Scale
Communications
Verification
Connect the Power Cable
to the facility outlet and
switch Main Circuit Breaker
to ON (I) position,
Did the Scale initialize?Did the Scale initialize?
Press the green ON (I) button on
the Operator’s Console, and
enter FmNT.
No
A
Locate and observe the green
LED on the Scale Control
Module.
Is the green LED
illuminated?
Is the green LED
illuminated?
In the FmNT Main Window,
click Configuration and select
Setup Scale.
Go to Scale Power
Verification
Yes No
In the FmNT Scale Setup
Window, Scale Operations tab,
observe the weight displayed
next to Current Reading.
Remove the Scale Cup.
Did the weight
displayed in the Scale
Setup Window
change?
Did the weight
displayed in the Scale
Setup Window
change?
Click the Zero Scale button.
Did the reading
change to and stabilize
at 0.00?
Did the reading
change to and stabilize
at 0.00?
On the Setup Scale D104 tab,
adjust the Filter and/or Stability
settings. (Refer to FmNT User
Guide or FmNT Online Help.)
Stop! Scale Operation is
not
root cause of fault.
Was the error
corrected?
Was the error
corrected?
No
Repeat steps indicated above
before proceeding.
Stop here. Filter/Stability is
root cause of Scale fault
Contact Asymtek
Technical Support
Yes No
Yes
Yes
Yes
No
Diagram Sheet 4-9-2
Scale Fault Isolation Procedure – Scale Operational Verification

Nordson Asymtek X-1010 Specifications

General

Brand	Nordson
Model	Asymtek X-1010
Category	Dispenser
Language	English