Nortek 2GIG eSeries GC2e - Wiring and Connections; LTE (Cellular) Radio Module Installation

B
A
A
B
GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 15 2GIG is a registered trademark of Nortek Security & Control LLC.
Figure 9 In-Wall Antenna Installation
Installation
1. Power ON the Control Panel.
2. Access the System Conguraon screen as follows:
a. At the Home screen, tap the system logo in the
lower-right corner.
b. At the Enter Your Code screen, enter the installer
code (the default code is 1561).
c. At the Installer Toolbox screen, tap System
Conguraon.
d. Tap Go To and then enter the code shown below to
respond to these programming quesons:
• Enter 08.
• Enter 11.
• Enter 12.
IMPORTANT: You must program the module in order to use it
with the Control Panel.
LTE (Cellular) Radio Module
If installing the LTE (Cellular) Radio Module, see below:
NOTE: The roung of the antenna wire is crical. You
must route the wire exactly as directed or cell radio
interference will occur.
1. When using external antennas, plug the antenna
connector into the LTE (Cellular) Radio Module.
The antenna drops into the wall or mounts in the
ac with the cable passing through the slot in the
Control Panel’s mounng plate.
A LTE (Cellular) Radio Module Connector
B End of antenna hangs down inside the wall
Figure 8 Attic Antenna Installation
The LTE (Cellular) Radio Module should already be
acvated by the factory. If not, contact the Remote
Service Provider. For the LTE (Cellular) Radio Module to
funcon, it must be acvated before it can be enrolled.
Enrollment is accomplished by creang an account with
the provider.
A Attic antenna mounted as high as possible
B Coaxial cable to Control Panel