Nortek 2GIG eSeries GC2e - Programming Navigation; Navigation Arrows & Go To Button; Questions without Sub-Options; Questions with Data Entry

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 26 2GIG is a registered trademark of Nortek Security & Control LLC.
Programming Navigation
When the installer is using the System Conguraon menus,
the Control Panel will present each programming queson
sequenally. Most programming quesons have a single
numeric value response or a simple enabled/ disabled selecon.
Some programming quesons have sub- opons that can be set.
These sub-opons are displayed for the queson selected and
can be accessed through navigaon keys on the display.
Navigation Arrows & Go To Button
The programming queson screens display up, down, le, and
right navigaon arrows. Use these arrows to scroll through the
programming quesons and to select sub- opons.
Tap the Go To buon and then enter a two (2)-digit code to
jump directly to a programming queson. See “Programming
Queson Table” on page 28. The Go To buon changes to Cancel
when waing for you to enter a queson number. Tap Cancel to
back out.
Figure 38
Navigation Arrows & Go To Button
• The ↑ and ↓ arrows select the next or previous
programming sub-queson.
• The ← and → arrows choose values for the queson on
or move the cursor le and right along the white data
entry eld.
Figure 40
Questions with Sub-options
Questions with Data Entry
Some of the programming quesons require entering
numeric or alphabec data. For devices that can be named,
the Control Panel contains a large vocabulary with words to
choose from. See “Voice Descriptors” on page 35.
• Tap Insert to display the rst word in the Voice
Descriptors list. Use the ← and → arrows to scroll
through the word list, or enter the corresponding three
(3)-digit code. See “Voice Descriptors” on page 35.
• Tap Backspace to move the cursor to the le and delete
one (1) character at a me.
• Tap Delete to delete one character to the right of the
cursor or any characters that are highlighted.
• Tap Forward to highlight the next word in a mul- word
data eld.
• Tap Back to highlight the previous word in a mul- word
data eld. The Back buon displays the previous screen
in some cases.
• Tap Shi to reveal alternate characters on the keypad
that can be used for data entry.
Figure 41
Questions with Data Entry
Questions without Sub-Options
Most of the programming quesons do not have sub- opons.
They navigate as follows. Quesons without sub- opons do
not display a Skip buon.
Figure 39
Questions without Sub-options
• The ↑ and ↓ arrows select the next or previous
programming queson.
• The ← and → arrows choose values for the queson
on or move the cursor le and right along the white
data entry eld.
Questions with Sub-Options
Some of the programming quesons have sub-opons.
They navigate as follows. Quesons with sub-opons
display a Skip buon during the queson. The Skip buon
advances to the next programming queson/secon.