Nortek 2GIG eSeries GC2e - Wireless (RF) Key Fob Programming; Q3: Select Fob Number; Q: Select Fob # Used; Q: Select Fob # Equipment Code

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 44 2GIG is a registered trademark of Nortek Security & Control LLC.
Sensor Chime
See Figure 49 Key Fob Programming Outline for the steps
required to program fobs into the Control Panel. The opons
that can be set for each fob are:
• Q3: Select Fob Number. Select key fob number 1-8.
• Q: Select Fob # Used. Select (0) Disabled or (1) Enabled.
• Q: Select Fob # Equipment Code. Select the four (4)-digit
equipment code that corresponds to the appropriate
keyfob. See “Equipment Codes” on page 37.
• Q: Enter Fob # Other Equipment Code. Enter the special
equipment code. This is only required when the Key Fob
# Equipment Code is set to (0000) Other.
• Q: Enter Fob # Serial #. Enter the serial number (typically
a label on the keyfob or the keyfob packaging) or tap
Shi then Learn to place the panel into learning mode.
Then trip the keyfob to transmit the serial number to the
panel.
• Q: Select Fob # Equipment Age. Specify whether the
sensor is a (0) New or (1) Exisng sensor.
• Q: Select Fob # Emergency Key. Choose the funcon of
double-tapping the top buons (0) Disabled, (1) Auxiliary
Alarm, (2) Audible Alarm, (3) Silent Panic, or (4) Fire.
• Q: Select Fob # Key # Can Disarm. Choose (0) Disabled or
(1) Enabled to specify if the key fob is allowed to disarm
the system.
• Q: Construct Fob # Voice Descriptor. Construct the
name assigned for the keyfob announcement. See “Voice
Descriptors” on page 35.
• Q: Select Fob # Arm No Delay. Choose if key fob will arm
the system instantly without an exit delay.
• Q: Select Fob # Key # Output. Select an acon for the key
fob auxiliary buon.
Wireless (RF) Key Fob Programming
The Control Panel can be programmed with up to eight (8) RF key
fobs.
Programming the fobs into the Control Panel involves selecng
the sensor number for a parcular device, seng or learning the
serial number, and selecng the other opons for the sensor.
IMPORTANT: RF key fobs 1 - 8 report to the Control Panel as
sensors 51 - 58 (opening/closing, emergency, and low baery
reports).
Code Sensor Chime
(0) Disabled
(1) Voice Only
(2) Ding-Dong with Voice #1
(3) Ding-Dong #2
(4) Ding-Dong with Voice #2
(5) Ding-Dong #1
(6) Ding-Ding
(7) Ding-Ding with Voice
(8) Ding-Dong #3
(9) Ding-Dong with Voice #3
(10) Chime #1
(11) Chime #1 with Voice #1
(12) Chime #2
(13) Chime #2 with Voice #2
Fob# Reports as Sensor#
1 51
2 52
3 53
4 54
5 55
6 56
7 57
8 58
Installer Programming