Nortek 2GIG eSeries GC2e - Final Installation Setup; Exiting Programming (System Configuration); Customizing the Installation

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 59 2GIG is a registered trademark of Nortek Security & Control LLC.
Final Installation Setup
Exiting Programming (System Configuration)
Aer programming the Control Panel, all the changes need to be
saved in memory. Aer saving, the programmed sengs will remain
in memory, even aer a total power loss.
1. Aer seng all the required programming values for the
sensors and the Control Panel, tap End.
2. Review the Summary of System Conguraon screen. Use the
↓ and ↑ arrows to scroll through the lisng. Verify that each
opon is set correctly.
Figure 51
Summary of System Configuration Screen
NOTE: User codes 0000, 0001, 000000, 000001 and the Installer
Code are not permied.
7. Setup each user code with the User Access Opon screen.
Each User Code can be set to be currently valid or not, or to
have condional validity. Refer to the User Guide for details
on seng User Code Access Schedules. When done, tap
Back.
8. At the Toolbox (1 of 3) screen, tap Brightness/Volume.
Then set the brightness level for the display screen and the
volume for the chime & voice. When done, tap OK.
Figure 53
Brightness/Volume Screen
9. At the Toolbox (1 of 3) screen, tap → to go to the Toolbox
(2 of 3) screen.
10. Tap Backlight Timeout. Then tap the buon that
corresponds to the number of seconds or minutes the
backlight turns OFF aer it is idle. When done, tap OK.
Figure 54 Back Light Timeout Screen
3. To save the programming changes, be sure the Save
Changes opon is checked. To exit without saving
programming changes un-check the Save Changes
opon (for vericaon, an addional conrmaon
screen appears). Tap Exit.
4. The Control Panel takes a few seconds to restart and
display the Home screen.
Customizing the Installation
Aer programming the Control Panel, go to the User Toolbox
and customize the system to suit the installaon. To access
the User Toolbox, do the following:
1. From the Home screen, tap Security.
2. From the Security screen, tap, Menu.
3. From the Menu screen, tap Toolbox.
4. Enter the master user code (the default master user
code is 1111).
5. Tap User Management.
6. To add, change, or delete a user code, tap a User #
buon. The system asks to conrm the code entered. Be
sure to set a Duress Code as User #8.
Figure 52
User Management Screen
NOTE: If the LTE (Cellular) Radio Module is properly installed
and registered, the system automacally sets the date and me
for you. Use the following steps only if you want to change the
date and me.