Nortek 2GIG eSeries GC2e - System Status Icons; Status Bar; Status Icons

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 25 2GIG is a registered trademark of Nortek Security & Control LLC.
Touch Screen Keypad Traffic
Figure 35 Touch Screen Keypad Trac
An up arrow indicates the panel is sending
informaon to the touch screen keypad (if installed).
A down arrow indicates the touch screen keypad is
sending informaon to panel.
Cell Radio
Figure 36 Cell Radio
If the opon LTE (Cellular) Radio Module is installed,
the Cell Radio icon appears while the Control Panel
is receiving Over-the-Air (OTA) rmware updates.
Interior sensor open
Figure 37 Interior Sensor Open
If an interior sensor is open (or a moon detector
has just been acvated) this icon appears. As a
warning, the icon ashes during arming.
System Status Icons
The top line of the Control Panel’s display is the status bar that shows the current system mode, the status of the sensors, and any current
system trouble alerts. Special icons are displayed on the right side to provide visual indicaons of the system’s current condion.
Figure 29
System Status Icons
A Status Bar
B Status Icons
AC Power On/OFF
Figure 30 AC Power ON
The AC Power icon shows the status of the
AC power to the Control Panel. A WHITE plug
appears when AC power is present.
Figure 31 AC Power OFF
The AC Power icon shows the status of the AC
power to the Control Panel. A RED “X” appears
over the WHITE plug when AC power is absent.
Sounder Disabled
Figure 32 Sounder Disabled
If the system’s internal sounder has been
lowered and external sounder has been
disabled by the installer for tesng, the sounder
disabled icon appears. It also ashes to indicate
silent arming.
Low Backup Battery
Figure 33 Low Backup Baery
If the Control Panel’s backup baery tests low,
the low backup baery icon appears.
Test Mode
Figure 34 Test Mode
This icon displays when the system is in Walk
Test mode.