Nortek 2GIG eSeries GC2e - Programming Controls; Additional Buttons

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 27 2GIG is a registered trademark of Nortek Security & Control LLC.
Additional Buttons
Depending on the programming queson, addional
buons may be displayed on screen:
• Tap Esc (Escape) to “undo” the previous acon. This is
useful when you want to restore the previous value for
the queson or sub-queson.
• Tap Sum (Summary) to reveal a summary of the values
stored for the queson and sub-opons.
• Tap End to reveal a summary of the values stored for
the enre Control Panel memory.
• Tap Learn to set the system to receive a sensor’s serial
number during programming.
• Tap Paste to repeat the last sensor serial number
entered.
• Tap Exit to exing the programming module.
Figure 42
Other Buttons Displayed
Programming Navigation