Nortek 2GIG eSeries GC2e - Keypad Configuration; Q: Select RF Keypad# Equipment Age; Q: Select RF Keypad# Emergency Keys; Q: Construct RF Keypad# Voice Descriptor

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 48 2GIG is a registered trademark of Nortek Security & Control LLC.
• The keypad displays “Network ID: xxxx” which is its unique serial
number.
• Tap OK on both the Control Panel and the Wireless
• Touch Screen Keypad to connue.
NOTE: The Wireless Touch Screen Keypad will display “The security
system is temporarily not operaonal” aer learning the Keypad. This
is normal, and will be displayed anyme the Control Panel is in system
conguraon (programming) mode.
Q: Select RF Keypad# Equipment Age (0 to 1)
DEFAULT: (0) New
The Control Panel can be used with new or exisng RF keypads.
• If this RF Keypad is new for the installaon, leave the default of
(0) New.
• If this RF Keypad is already installed, select (1) Exisng.
Q: Select RF Keypad# Emergency Keys (0 to 1)
NOTE: This step is not displayed for Wireless Touch Screen keypads.
DEFAULT: (1) Enabled
Standard wireless keypads have 24-hour emergency buons labeled Fire
and Police.
• The default (1) Enabled enables this RF Keypad’s emergency keys.
• To disable this RF Keypad’s emergency keys, select (0) Disabled,
the keys will not be able to trigger an alarm or report.
NOTE: The RF Keypad’s POLICE buon triggers a silent alarm if
programming queson Q16: Police Emergency Key (0‐2) is set to (2)
Silent Panic. See “Q16: Police Emergency Key” on page 50.
IMPORTANT: To ensure that a signal is sent, instruct the end user to tap
and hold down the emergency key on the keypad unl its indicator light
illuminates.
Q: Construct RF Keypad# Voice Descriptor
DEFAULT: (#) Keypad
The voice descriptor is the words the Control Panel will announce for
this RF Keypad. Up to ve words are allowed.
1. Tap Insert to place a word from the vocabulary into the data entry
eld.
2. Use the ← or → arrows to scroll through the words, or enter the
word’s 3-digit index number.
3. Tap Insert again for the next word. Up to ve words are allowed.
4. To remove a word, tap Delete.
Installer Programming