文件编号：NR-TP-0715-008 版本：1.0
- 7 -
Make sure that the AC power supply meets the following specifications: AC 100V ~
240V, 50/60Hz.
Use the power cord provided with the monitor. Plug the power cord into the power
connector of the monitor, and plug the other end of the power cord into the mains (low
voltage power supply network facilities) power outlet with protective earthing.
Note
Connect the power cord to the dedicated outlet in the hospital.
2.4 Turning On
2.4.1 Checking the Monitor
Before turning on, check whether there is mechanical damage to the monitor, and
whether the external cables and accessories are connected correctly.
Plug the power cord into the AC power outlet. If using battery power, make sure the
battery is fully charged.
Check all the functions required for patient monitoring to make sure that the monitor
works properly.
Warning
If the monitor is damaged, or fails to work normally, do not use it for patient
monitoring. Please contact the maintenance personnel or Northern immediately.
2.4.2 Starting the Monitor
After checking the monitor, you'll be ready to start the monitor.
Press the power switch, the yellow and red warning lights flash once in turn, and the system
enters the program reading interface; then the company's LOGO is shown; finally, the system
makes a “tick” sound, the boot screen disappears, and the system enters the main interface.
If the yellow and red warning lights flash once in turn when the device is turned on and the
To Next Page
Loading...