文件编号：NR-TP-0715-008 版本：1.0
- 26 -
f) Select [Paced], and set whether the patient wears a pacemaker according to the
patient condition:
[Yes]: The patient wears a cardiac pacemaker.
[No]: The patient does not wear a cardiac pacemaker.
g) Select [High (cm)], and set the patient’s height via the pop-up keyboard on the
screen.
h) Select [Weight (kg)], and set the patient’s weight via the pop-up keyboard on the
screen.
i) Select [Blood Type], and set the patient’s blood type:
[A]: Patient blood type is A.
[B]: Patient blood type is B.
[AB]: Patient blood type is AB.
[O]: Patient blood type is O.
[Others]: Other blood type of the patient.
j) Select [Admit date (yyyy-mm-dd)], and set the date of admitting the patient.
k) Select [Birthday (yyyy-mm-dd)], and set the birth date of the patient.
After setting, select [OK] to save the current setup; select [Cancel] and do not save the
current setup.
5.4 Editing Patient Info
When the monitor has admitted a patient, but the patient information is incomplete, or needs to
be changed:
Select the patient info area on the display to pop up [Patient Info] menu as shown in Fig. 4-3,
and complement or change the patient info in the [Patient Info] menu; see 4.2 for specific
operation.
5.5 Discharging a Patient
To discharge a patient, operate as follows:
In the [Patient Setup] menu, select [Discharge Patient] → [Warning] → [OK] to finish the
operation of discharging a patient.
To Next Page
Loading...
Need help?
General