Northern Meditec Taurus E - Chapter9 PR; Overview; Display; Pulse Vol

To Next Page

To Previous Page

文件编号：NR-TP-0715-008 版本：1.0

- 45 -

Chapter9 PR

9.1 Overview

The mechanical activity of the heart causes arterial pulsation, and PR (pulse rate) value can

be obtained by measuring this pulsation. PR value can be obtained through SpO2

measurement.

9.2 Display

The color of PR parameter area is same as SpO2 parameter color of PR source, as shown in

Fig. 9-1:

Fig. 9-1 PR Parameter Area

9.3 Pulse Vol.

Select SpO2 parameter area or Pleth wave area → [SpO2 Setup] menu;

Select [Pulse Vol.] to set [Pulse Vol.] to 0~9, and plus / minus 1 each time the shuttle is

turned. Select 0 to turn off the key-pressing tone, and select 9 to set the maximum volume.

Note

 HR sound has higher priority than PR sound; when HR makes a sound, PR won’t;

when HR sound is 0, PR can make a sound.

9.4 Alarm Setup

Select PR parameter area → [SpO2 Setup] menu → [Alarm Setup >>] to enter the [Alarm

Setup] interface, and set PR alarm switch, alarm level and upper/lower alarm limit. See 6.5