Northern Meditec Taurus E - Chapter12 ECG; 12.1 Overview and Safety; 12.3 Monitoring Steps; 12.4 ECG Display

文件编号：NR-TP-0715-008 版本：1.0
- 8 -
monitor makes a “tick” sound, the warning system of the monitor can work normally.
Notes
 If any fatal error occurs during self-test, the system will alarm.
 Check all available monitoring functions to ensure that the monitor functions
properly.
 If the monitor integrates a battery, charge the battery after each use to secure
sufficient power.
2.4.3 Connecting the Sensor
Connect the required sensor to the monitor and the monitoring position on the patient.
Note
 For proper connections and related requirements for a variety of sensors, see
Chapters 7-12.
2.4.4 Starting Monitoring
Start monitoring in the following steps:
 Check if the patient cable and the sensor are connected properly.
 Check if the settings of the monitor are correct, such as: patient category [Patient Cat.]
 For the details of parameter measurement or monitoring, see the appropriate section.
2.5 Turning off
Please turn off the monitor in the following steps:
 Disconnect the cables and sensors connected to the patient.
 Press and hold the power switch for two seconds to pop up the 5sec countdown window,
and the monitor turns off in five seconds.
Caution