NorthStar EXPLORER 650 - 2-2 Turning on and off; auto power

11Northstar Explorer 650 Installation and Operation Manual
a To change a tick box
means On or Yes
means Off or No.
Press
or to change the tick box.
b To select an option
1 Press
to display the menu of options.
2 Press or to move the highlight to the
option you want, then press .
c To change a name or number:
1 Press
to display the name or number:
2 Press
or to select a letter or digit to
change. Press
or to change the letter or
digit.
Repeat this to change other letters or
numbers.
3 Press
to accept the new value. Or press
to ignore the changes.
d To change a slider value
Press
to decrease the value or to increase
the value.
2-2 Turning on and off / auto power
Turning on manually
If the Explorer is not wired for auto power, press
to turn the unit on. If necessary, adjust the
display to be easy to read (see section 2-3).
Note: If the Explorer is not wired for auto power
then the Explorer does not record engine hours
and might not record fuel consumption (see
section 18-4).
Turning off manually
If the Explorer is not wired for auto power or if
the ignition switch is off, hold down until the
display turns off.
Auto power
If the Explorer is wired for auto power (see
section 18-4), then:
• The Explorer automatically turns on when you
turn the boat’s ignition switch on.
• You can not turn the Explorer off while the
ignition switch is on.
• If Auto power off (see section 17-1) is
, the
Explorer automatically turns off when you
turn the boat’s ignition switch off.
• If Auto power off (see section 17-1) is
, the
Explorer stays on when you turn the boat’s
ignition switch off. You can now turn the
Explorer off manually.