Notifier AFP-400 - Page 95

Wiring a Signaling Line Circuit (SLC)  ,QVWDOODWLRQ
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97 2-59
6W\OH = 1$& &LUFXLWV
0HWKRG  ² 036
SRZHUV &0;
Figure 2-78 shows a second method of powering a CMX from an MPS-400 NAC. (See
Figure 2-77 on page 2-58 for the first method.) The NAC is supervised and
power-limited. When an MPS-400 NAC supplies power to CMX modules:
• The CMX module outputs are coded if the MPS-400 NAC is coded.
• Program the MPS-400 NAC for general alarm. (Refer to the Programming Manual
for instructions.)
1RWH 5HIHU WR WKH 'HYLFH
&RPSDWLELOLW\ 'RFXPHQW IRU
FRPSDWLEOH QRWLILFDWLRQ
DSSOLDQFHV
Connect the NAC as follows:
1. Connect the SLC to CMX terminals 1 (–) and 2 (+).
2. Connect 24 VDC power from an MPS-400 NAC (TB7-TB10) to CMX terminals 3
and 4.
3. Terminate the power feed to the CMX module with a 2.2K ELR (PN R-2.2K) or
make the power feed a return to MPS-400 NAC terminals 3 and 4 (Figure 2-78).
4. Set the CMX rotary switches to the required SLC address. (The CMX takes one
module address on the SLC.) For instructions on setting rotary switches, see
Figure 2-68 on page 2-49.
)LJXUH  1)3$ 6W\OH = 1RWLILFDWLRQ $SSOLDQFH &LUFXLW 0HWKRG 
 9'& 1RWLILFDWLRQ
$SSOLDQFHV
1RWH 'R QRW ORRS ZLULQJ XQGHU DQ\ WHUPLQDOV %UHDN ZLUH UXQ WR
PDLQWDLQ VXSHUYLVLRQ 036,&0 1$& &RQILJXUDWLRQV RQ SDJH
 FRQWDLQV GHWDLOHG LQIRUPDWLRQ RQ ZLULQJ DQ 036 1$&
&38 RQO\
WR QH[W GHYLFH RQ 6/&
²
6/&  WR 7%
6/& ² WR 7%
. (/5
31 5.
 9'&  WR 7%[
 9'& ² WR 7%[
7%[ 7% 7%  7%   RU 7% 
&0;
&0;
&38036 
5HWXUQ RSWLRQDO IRU
6W\OH <
(/5 VHH
QRWH
(/5 ² (QG RI /L QH
5HVL V WRU  .  ZDWW
SDUW QXPEHU
66' $ 8VH DQ
1(/5 LQ & DQDG D
www.PDF-Zoo.com