NSK MEGATORQUE M-ESA-Y3040T25 - Page 66

— 5-7 —
u Setting Example
1) Press the code key while holding down the SHIFT key.
:
:?_
0
?
SHIFT
2) Input the command to read the setting of the AB parameter. Check the current polarity
setting (in this example, all the input ports are set to A contact).
:
:?AB
ABX0X0XX00
:_
ENT
BA
3) Input the password.
The password acknowledgment message appears on the display.
ABX0X0XX
00
:/NSK ON
NSK ON
:_
SN/
SP
K
ENT
NO
4) The second bit following AB represents EMST. Set this bit to “1”, and the other bits to
“X” (no change).
:/NSK ON
NSK ON
ABX1XXXXXX
:_
XBA X X1
#
XX X
ENT
X
l Thus, the polarity of EMST input signal port has been changed to B contact.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com