NXP Semiconductors PN544 C2 - Page 70

NXP Semiconductors
UM191812
PN544 C2 User Manual
191812 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
User Manual Rev. 1.2 — 2010-06-16 70 of 172
Id Name Access
Rights
Comment Length Default
4. ‘03’ 5. NXP_SWP_PROTECTION_MODE 6. RW
7. (Reg
6
)
8. Indicates if the protected mode is
enabled (see below a description of
the protection mode feature) :
9. 0x00 -> Disabled
10. 0x01 -> Enabled
Others values are RFU
1 0x00
Information of a transaction occurs with an application located in the UICC is shared
through the ETSI HCI standard [1] “triggering proactivity events” mechanism.
Not connected
Connecting
Connected
Connection failed
Connection lost
Disconnecting
Activating SWP
Deactivating
SWP
Activation
sequence ?
failed
succeed
Deactivating
SWP
Re-activating
SWP
Link broken
transitory states
Re-Activating
SWP
Fig 42. SWP states diagram
6.
‘Reg’ means that this information is stored in HW register -> Persistent while IC is powered ON (and no
VEN reset occurs)