Observint DVR9004N - DVR Setup; Login To The Dvr; SECTION 3 DVR Setup

16
SECTION 3: DVR SETUP
SECTION 3
DVR Setup
Setting up your DVR includes logging into your DVR, setting the clock, setting administrator and user account passwords, and
setting up scheduled and/or automated motion recording.
NOTE
The following sections provide a generic procedure for setting up a system with a DVR9004N series DVR. If you are setting up an
8- or 16-channel system, the displays you see may be slightly dierent. For example, if you have an 8-channel DVR, the initial DVR
camera channel display will be an 8-split screen, one split for each channel.
3.1 Login to the DVR
Initially, two access accounts are provided in your system: Admin and user1. With the Admin login, you can make conguration
changes to the system, create user accounts and passwords, and control the privileges allotted to each account. With the factory
default user1 account login you cannot make conguration changes or create accounts, but can change your own password. The
factory default Admin and user1 account passwords are:
Admin: 888888
user1: 666666
To log into the system:
1. Power on the DVR and wait until it advances to the camera view screen. A typical camera view screen is shown below.
Image from
Channel 1
Camera
NOTE
During initial startup of the system, no password is required.