2.6 Turning on
− Turn the scale on using the switch at the right bottom of the scale.
ð The GEO value and the software version are displayed.
ð The scale is ready when the weight display appears.
The display may turn off automatically after 10 minutes if this is configured in the energy saving
settings.
2.7 Turning off
− Turn the scale off using the switch at the right bottom of the scale.
After 5 minutes an automatic backup is initiated. Restarting the scale during this process may take
more time than usually.
2.8 Restarting
− Press the switch at the right bottom of the scale until the message System is restarting
appears.
2.9 Cleaning
CAUTION
Damage to the device
1 Turn off and unplug the device before cleaning.
2 Do not open the device.
3 Make sure that no fluids get inside the device.
4 Do not use scouring powders or plastic dissolving cleaning agents for cleaning.
1 Remove the weighing pan and clean it with a commercially available household detergent.
2 If heavily soiled, clean the surface of the device with a damp cloth that has been dipped in water
containing a mild washing-up liquid and has been wrung out well.
Setup and device settings12 Skippper 5000
To Next Page
Loading...
