Configuring the "Client" scale
You need to configure each client scale individually.
1 Enter the menu and navigate to sub-menu F251 Network.
2 Ensure that "IP Mode" is set to "Automatic".
ð This configuration ensures that your scales are in a network
and can communicate with each other.
3 Navigate to sub-menu F257 Data Server.
4 Define the scale as "Client" by changing the "Data Server Type" to
"Retrieve Auto".
5 Navigate to sub-menu F211 Item Recall.
6 Ensure that "Source of PLU" is set to "Remote + Local".
7 Ensure that "Data Synch at Start up" is set to "Enable".
8 Navigate to sub-menu F233 Vendor.
9 Set "Vendor Mode" to "Floating Vendor".
10 Restart the client scale/s in order to synchronize the item data,
e.g., vendor, group etc., with the "Data Server/Master" scale.
F251
OK
OK
F257
OK
OK
IP Mode: Automatic
Client:
OK
OK
Vendor Mode: Floating Vendor
OK
F211
Source of PLU: Remote + Local
OK
Data Synch at Start up: Enable
OK
F233
Data Server Type: Retrieve Auto
To Next Page
Loading...
