- 241 -
Setting the network from the web browser
5
1
2
4
3
Convenient print
functions
Appendix Index
Checking and
Changing Printer
Settings Using
the Control Panel
Network
Setup
Matching
Colors
Using Utility
Software
4
[Enable] the [MAC Address Filtering] in
[STEP1].
5
Select whether to [Accept (Deny)]
communications from a specic MAC
address in [STEP2].
Note
z
Use the MAC address to enter the host MAC address
that authorizes (or denies) the communications.
z
For the MAC address, use single-byte numbers
separated by ":".
z
Regardless of the specications in Step 2, the
administrator addresses that can communicate can
be set in Step 3.
6
Set the value in [Administrator’s MAC
Address setting] in [STEP3].
Even if the incorrect settings were made in
[STEP2] by entering the administrator MAC
address in [Administrator’s MAC Address
setting], the administrator can reset from
the MAC address host set in [Administrator’s
MAC Address setting].
Note
z
If accessing the device via a proxy, the address of
the proxy device will be displayed as [Your host
MAC address]. Consequently, the [Your host MAC
address] displayed in your host address may differ.
z
If nothing is registered as the administrator MAC
address, access to the device may be completely
disabled depending on the settings in Step 2.
z
If you do not wish to register an administrator
MAC address, enter "00:00:00:00:00:00" in the
[Administrator’s MAC Address setting].
7
Click [Submit].
8
The settings will be save in the printer,
and the network functions will restart.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
