- 47 -
Printing on various papers
4
1
2
3
5
Apéndice Índice
Comprobar y cambiar
la conguración de la
impresora utilizando el
panel de control
Cong de
red
Concordar
los colores
Utilización
de software
de utilidades
Funciones de
impresión útiles
Printing on user-selected
paper sizes (custom pages
and lengthy printing)
Register the desired paper size in the printer
driver, and specify when printing.
[Sizes that can be fed from the Multi-
Purpose Tray (Settable custom sizes)]
Width: 64 to 330mm
Length: 89 to 1321mm
[Sizes
that
can be fed from the Multi-
Purpose Tray]
Trays 1/2/3/4/5
Width: 99 to 330mm
Length: 147 to 457mm
[Sizes where 2-sided printing is possible]
Width: 99 to 330mm
Length: 147 to 483mm
Note
z
If printing smaller paper than width 99mm and length
147mm, feed from the Multi-Purpose Tray and output to
the face-up stacker.
z
Set the paper size to portrait length, and set in the device.
z
Not usable with some applications.
z
If feeding from the Multi-Purpose Tray, support the paper
manually for paper lengths that are not fully supported by
the paper supporter.
z
If feeding from the paper trays (tray 1, (optional)
trays 2 to 5), press the scroll buttons
or on
the device control panel, and select [Menu]>[Tray
Conguration]>[Set Tray 1]>[Paper Size]>[Custom].
z
If there is no paper in the tray, setting the function to
switch automatically to a tray in which paper of the same
size has been set, the default settings will be enabled
(i.e., the check box will be enabled). If the paper runs out
during printing, paper will feed from another tray. Disable
(i.e., uncheck) the check box when printing custom size
paper from a designated tray only.
1
Set the paper.
Memo
z
You can print by manually feeding one page at a
time from the Multi-Purpose Tray. For details, see
“Printing single sheets manually” (P.81).
Setting in the Multi-Purpose Tray
ABC
Setting the paper
orientation
Setting in the paper tray
Setting the paper
orientation
2
If outputting to the face-up stacker,
open the face-up stacker.
Set the print surface face-up to output.
Memo
z
You can output to the face-down stacker.
Face-up stacker
To Next Page
Loading...
Need help?
General
Weight and Dimensions
