- 286 -
Table of setting items in the device setup screen
1
2
3
5
4
Convenient print
functions
Appendix Index
Checking and
Changing Printer
Settings Using
the Control Panel
Network
Setup
Matching
Colors
Using Utility
Software
z
Shaded areas are factory-set values.
Item Details
SMR settings 0
+1
+2
+3
-3
-2
-1
Compensates for print results variation due to
differences in the temperature and humidity
environments, print density, and print frequency.
Changes the settings if there is burr in the image.
BG settings
0
+1
+2
+3
-3
-2
-1
Compensates for print results variation due to
differences in the temperature and humidity
environments, print density, and print frequency.
Change the value if the underlay is dark.
Drum cleaning
ON
OFF
Sets whether to implement drum cleaning before
printing. The image quality may be improved.
Transfer roller cleaning Implement Implements cleaning of the transfer roller unit.
High Humid Mode
Mode 1
Mode 2
OFF
Set if the paper curl after printing is conspicuous.
Try mode 2 if reduced paper curl effects are not
obtained after settings mode 1.
Setting mode 1 or mode 2 will increase the warm-
up time and reduce the print speed.
Condensation control
ON
OFF
Sets whether or not to implement condensation
control.
If [ON], completing the printing of 1 page may
take time.
Narrow width paper speed
Normal
Slow
Sets the speed when printing on narrow paper.
Print mode
Normal
Slow
If there is toner peeling when there is friction
between printed sheets, set to "Slow". Peeling
may be cured.
Setting Slow will reduce the print speed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
