Oki C911dn

- 294 -
Table of setting items in the device setup screen
1
2
3
5
4
Convenient print
functions
Appendix Index
Checking and
Changing Printer
Settings Using
the Control Panel
Network
Setup
Matching
Colors
Using Utility
Software
z
Shaded areas are factory-set values.
Item Details
A4 character width 78 digits
80 digits
Sets the number of digits until an auto carriage
return on A4 paper.
Blank page exclusion
ON
OFF
Sets whether not to print blank pages.
CR operations
CR only
CR+LF
Sets the operations when receiving CR codes.
LF operations
LF only
LF+CR
Sets the operations when receiving LF codes.
Print area
Normal
1/5"
1/6"
Sets the are of the paper where printing is not
possible.
Image black selection
Black only
Mixed black
Sets whether to print image data black using mixed
CMYK or print using black toner only.
Pen width compensation
ON
OFF
Compensates so that thin lines are visible.
Tray ID# MPT
1
to
4
to
59
Species the number of the Multi-Purpose Tray
specication using the output specication
command in the PCL commands.
Tray 1
1
to
5
to
59
Species the number of the tray 1 specication
using the output specication commands in the PCL
commands.
Tray 2
*1
*1: The optional expansion
tray unit is displayed when
mounted.
1
to
5
to
59
Species the number of the tray 2 specication
using the output specication commands in the PCL
commands.
Tray 3
*1
*1: The optional expansion
tray unit is displayed when
mounted.
1
to
20
to
59
Species the number of the tray 3 specication
using the output specication commands in the PCL
commands.
Tray 4
*1
*1: The optional expansion
tray unit is displayed when
mounted.
1
to
21
to
59
Species the number of the tray 4 specication
using the output specication commands in the PCL
commands.
Tray 5
*1
*1: The optional expansion
tray unit is displayed when
mounted.
1
to
22
to
59
Species the number of the tray 5 specication
using the output specication commands in the PCL
commands.