Oki C9850

Oki Data CONFIDENTIAL
43627911TH Rev. 3
168 /
5.3 Density Correction
When the printer is shipped, the Automatic Density Correction Mode is set to “Automatic”. If it is
set to “Manual” there may be drifting during use. Set this if there is any problem with the density.
Note! Set this when the printer is not running (Stop State). Do not set this while the printer
is
warming up.
(1) Press the [ENTER] key several times. The [Color menu] will appear.
(2) Press the [MENU+] or [MENU-] key to display the [Density Correction/Execute].
(3) Press the [ENTER] key.
Automatic Density Correction starts.