Oki MC873dn - Page 118

45850101TH Rev.1
3-9
Oki Data CONFIDENTIAL
3. MAINTENANCE MENUS
Item1 Item2 Item3 Item4 Item5 Value
Default
value
ODA
Default
value
OEL
Default
value
JP
Notes
Password Scanner
Maintenance
Mechanical
Tes t
ADF Hopping
Motor Test
Forward
Forward Continuous
Reverse
Reverse Continuous
Test the ADF Hopping motor
①
After a short press of the button, rotate in the CW direction for 10
seconds and then stop.
②
After a long press of the button, rotate in the CW direction
continuously. Stop when the Stop button is pressed.
③
After a short press of the button, rotate in the CCW direction for 10
seconds and then stop.
④
After a long press of the button, rotate in the CCW direction
continuously. Stop when the Stop button is pressed.
Deemed successful at all times. No need to display results.
Display "Testing" during execution?
→
Display a message on the panel showing that testing is underway.
ADF Transfer
Motor Test
Forward
Forward Continuous
Reverse
Reverse Continuous
Test the ADF Transfer motor
①
After a short press of the button, rotate in the CW direction for 10
seconds and then stop.
②
After a long press of the button, rotate in the CW direction
continuously. Stop when the Stop button is pressed.
③
After a short press of the button, rotate in the CCW direction for 10
seconds and then stop.
④
After a long press of the button, rotate in the CCW direction
continuously. Stop when the Stop button is pressed.
Deemed successful at all times. No need to display results.
Display "Testing" during execution?
→
Display a message on the panel showing that testing is underway.
Multi Feed
Sensor Test
Display ResultResult Min
Ave
Max
Display the Multi Feed Sensor detect voltage (Min/Ave/Max) of last
page when reading from ADF.
Sensor Test Execute Start the Multi Feed Sensor Test
Confirm the result with "Display Result".
Adjust
Accuracy
Correction
value
-10~20 0 0 0 Adjust the accuracy of Multi Feed detect level.
(Value) 1=+0.05V (Decrease the value, the sensitivity has down)
Adjust Cycle Correction
value
0~25 0 0 0 Adjust the cycle of Multi Feed detect length.
(Value) 1=1cycle
Fax
Maintenance
Service Bit
* When
OKIUSER is
set by JP1
or JPOEM1,
this item is
displayed.
ON
OFF
- - OFF If set OFF, some menu items are not displayed on the panel.
When OKIUSER is set on except for JP1 or JPOEM1, this item is
displayed in the top of a menu of 'Admin Setup'-'Fax Setup'-'Fax
Setting'.