45850101TH Rev.1
4-12
4.2.9 HDD Assy / Plate Assy.-Sensor / Stapler Unit
(1) Remove the plate shield (Refer to section 4.2.8).
(2) Disconnect the cable of the HDD Assy
①
from the Main board
.
(3) Remove the three screws(silver)
②,
and up slightly to detach the HDD Assy
①
.
(4) Disconnect and remove the cord
③,
and remove a screw(silver)
④
to detach the
Plate Assy.-Sensor
⑤
.
(5) Remove the screw (silver)
⑥
and detach the Holder-WLAN
⑦
with the WLAN-
cable
⑧
.
(6) Remove the three screws (silver)
⑨
and disconnect the cables from the Main board
to detach the Stapler Unit
⑩
.
③
①
⑤
④
②
⑥
⑦
⑧
⑨
⑩
To Next Page
Loading...
