45850101TH Rev.1
4-42
8 released points
③
⑤
④
⑥
⑦
4.2.21 High-voltage power supply board
(1) Remove the image drum unit/belt unit. (Refer to section 4.2.1)
(2) Detach the cover side-L Assy. (Refer to section 4.2.3)
(3) Remove the three screws (black)
①
and a screw (silver)
②
, release the high-
voltage power supply board
③
with unlatching the seven claws, disconnect the FAN
(Fuser) connector
④
, the belt thermistor connector
⑤
, the cover-open sensor
connector
⑥
, and the FFC connector
⑦
, and detach the high-voltage power
supply board
③
.
To Next Page
Loading...
