32
Electronic Journal Reports
An electronic journal report executed with the control key in the X position does not clear the electronic journal memory
(and therefore all transaction data are retained) while the report executed with the control key in the Z position cancels
electronic journal memory thus restoring it to its maximum line capacity programmed.
To momentarily interrupt report printing, press
. Press this key again to resume printing.
To cancel report printing, press
.
Complete Electronic Journal Report
This report is a complete listing of transaction receipts and Z financial reports taken within the maximum line capacity
programmed.
1. Control key position: X or Z. Bear in mind that in the Z position the electronic journal memory contents are cleared after
you press
. Make sure there is plenty of paper loaded in the printer.
2. If a manager password was defined type the [4-digit password] and press
.
3. Press .
When the contents of the electronic journal are printed, a message is displayed along with a beep to indicate that the EJ
memory capacity has been restored to its programmed line capacity.
Oldest Transaction Report
By entering the number of transactions you wish to view, this report prints the selected number of oldest receipts and Z
financial reports performed and stored within the programmed line capacity.
1. Control key position: X or Z. Bear in mind that in the Z position the journal report contents are cleared. Make sure there
is plenty of paper loaded in the printer.
2. If a manager password was defined type the [4-digit password] and press .
3. Type a number between [001 and 999] indicating the number of oldest reports wanted and press
.
Latest Transaction Report
By entering the number of transactions you wish to view, this report prints the most recent receipts and Z financial reports
performed and stored within the programmed line capacity.
1. Control key position: X or Z. Bear in mind that in the Z position the journal report contents are cleared.
Make sure there is plenty of paper loaded in the printer.
2. If a manager password was defined type the [4-digit password] and press
.
3. Type a number between [001 and 999] indicating the number of latest reports wanted and press .
Daily Report
By entering the number of Z financial reports that you wish to view, this report prints the receipts recorded before the
defined Z financial report along with the report itself.
1. Control key position: X or Z. Bear in mind that in the Z position the journal report contents are cleared. Make sure there
is plenty of paper loaded in the printer.
2. If a manager password was defined type the [4-digit password] and press
.
3. Type a number between [01 and 99] indicating the number of oldest end-of-day reports wanted and press .
To Next Page
Loading...
