Omnicomm Profi - Fuel Level Sensors Setup

Sensors with analog output
“Minimum measured value” – set the minimum value to be measured by the sensor
(in the units of measurement of this value).
“Voltage corresponding to the minimum value” – set the value of voltage
corresponding to the minimum measured value.
“Minimum measured value” – set the minimum value to be measured by the sensor
(in the units of measurement of this value).
“Voltage corresponding to the maximum value” – set the value of voltage
corresponding to the maximum measured value.
“Current voltage at universal input” – value of the voltage at the universal input of
the Terminal.
“Current value of measured parameter” – current measured value.
“Equipment name” – enter the monitored parameter name.
Analog sensor types:
with uniform current output:
with uniform voltage output:
54
Additional Equipment