257
3. Specify the start address for the data that is to be restored or compared.
4. Start playing the cassette tape.
5. Within 5 seconds, press SHIFT and PLAY/SET to restore data or VER to
compare data.
Program restoration or comparison continues until END(01) is reached or
until the tape is finished, at which time the program size in Kwords is dis-
played. At that time the program size in Kwords is displayed. Even if END(01)
is reached before the end of the tape, the restoring or comparison operation
will continue through the end of the tape unless CLR is pressed to cancel.
Key Sequence
PLAY
SET
EXT
A
0
WRITE
CLR
SHIFT
Start tape recorder
playback.
[File no.]
[Start address]
Within about 5 seconds**
**These times take the cassette leader tape into consideration according to the following:
a) When recording to tape, the leader tape needs to be allowed to pass before the data transmission to the tape player starts.
b) When restoring from tape or comparing data, the Programming Console needs to be ready to receive data before the data is transfered
from the tape.
Program Backup and Restore Operations Section 7-2
To Next Page
Loading...
