64
Key Sequence
Both AR and HR areas
TC area
DM area
Program Memory cleared
from designated address.
Retained if pressed
The following procedure is used to clear memory completely.
Continue pressing
the CLR key once for
each error message
until “00000” appears
on the display
All clear
MEMORY ERR
I/O VER ERR
00000
00000 MEM CLR ?
HR CNT DM
00000MEM CLR
END HR CNT DM
00000
It is possible to retain the data in specified areas or part of the Program
Memory. To retain the data in the HR and AR, TC, and/or DM areas, press
the appropriate key after entering REC/RESET. HR is pressed to designate
both the HR and AR areas. In other words, specifying that HR is to be re-
tained will ensure that AR is retained also. If not specified for retention, both
areas will be cleared. CNT is used for the entire TC area. The display will
show those areas that will be cleared.
It is also possible to retain a portion of the Program Memory from the begin-
ning to a specified address. After designating the data areas to be retained,
specify the first Program Memory address to be cleared. For example, to
leave addresses 00000 to 00122 untouched, but to clear addresses from
00123 to the end of Program Memory, input 00123.
All Clear
Partial Clear
Preparation for Operation Section 4-5
To Next Page
Loading...
