Omron CK3M Series User Manual


AbortAll
Register name Sys.AbortAll
Description Stop based on Abort all input
Range 0 to 1
Details 0: No stop based on Abort all input
1: Stopped based on Abort all input, or stopped in the past based on "Abort all" input.
Detection timing With Abort all input
Recovery Cycle the power supply, reset command ($$$)
Effects Operation continues
Cause and cor-
rection
Cause (Assumed cause) Correction Prevention
Abort all was input. None None
Precautions/
Remarks
None

NoClocks
Register name Sys.NoClocks
Description Cannot detect a phase clock or a servo clock.
Range 0 to 1
Details 0: No error
1: Cannot detect a phase clock or a servo clock.
Detection timing When power is turned ON or reset
Recovery Cycle the power supply, reset command ($$$)
Effects Cannot enable the motor.
Cause and cor-
rection
Cause (Assumed cause) Correction Prevention
A Unit that supplies servo
clock and phase clock sig-
nals is installed to the Ex-
pansion Rack.
Install the Unit that supplies
clock signals to the CPU
Rack.
None
The clock-related register is
overwritten by the user pro-
gram.
If the error no longer occurs
after the re-initialization
command ($$$***) is exe-
cuted, review the user pro-
gram.
None
The CPU Unit or the CK3W
Unit has failed
If this error persists even
after you make the above
corrections, replace the
CPU Unit or the CK3W
Unit.
None
Precautions/
Remarks
None
6 Troubleshooting
6-13
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
6-4 Sys.Status Register
6
6-4-2 Details of Flags

Omron CK3M Series Specifications

General

Brand	Omron
Model	CK3M Series
Category	Controller
Language	English