Omron fh series - Page 30

2 Basic Operations
2 - 2
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
Precautions for Correct Use
• The data being synchronized varies depending on the connection method (i.e., Ethernet
direct connection or connection through an NJ/NX-series Controller) between the FH sensor
controller and the computer that runs Sysmac Studio.
• For information on connection through an NJ/NX-series Controller, refer to 2-8 Precautions
on Synchronization through an NJ/NX-series Controller on page 2-39