Omron fh series - Precautions on Synchronization through an NJNX-Series Controller

2 - 39
2 Basic Operations
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
2-8 Precautions on Synchronization
through an NJ/NX-series Controller
2
2-8 Precautions on Synchronization
through an NJ/NX-series Controller
The contents of the Sysmac Studio project data and the data being synchronized vary depending on
the connection method (i.e., Ethernet direct connection or connection through an NJ/NX-series Control-
ler) between the FH sensor controller and the computer that runs the Sysmac Studio. Particularly, the
settings data for the FH sensor controller cannot be synchronized via an NJ/NX-series Controller.
This section describes precautions on performing the system synchronization from the System Studio
via an NJ/NX-series Controller.
For the overview, refer to 1-2-2 Project Data Handling in Different System Configurations on page 1-5.
USB/Ethernet
EtherCAT
Uploading
Sysmac Studio NJ/NX
FH
Downloading