2 - 41
2 Basic Operations
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
2-8 Precautions on Synchronization
through an NJ/NX-series Controller
2
2-8-2 Saving and Loading the Settings Data for the FH Sensor Controller
This section describes procedures for saving and loading the settings data for the FH sensor controller
using the external memory.
Saving and loading the settings data for the FH sensor controller
The following procedures describe how to save and load the settings data for the FH sensor control-
ler that is in the FH sensor controller to the external memory. Save and load following four types of
the settings data individually.
(1) System + Scene group 0 data
Refer to the following:
(2) Data for scene groups 1 to 31
Refer to the following:
(3) Communications command macro data
Refer to Saving and Loading Programs in Vision System FH/FZ5 series Macro Customize
Functions Programming Manual (Cat. No. Z367).
(4) Security settings data
Refer to Saving/Loading/Deleting the Security Settings in Vision System FH/FZ5 Series
User's Manual (Cat. No. Z365).
Precautions for Correct Use
• If the FH sensor controller is in the Multi-line Random-trigger Mode, the settings data for the
FH sensor controller must be saved and loaded for each individual line.
• During saving, do not restart, turn OFF the power supply, or remove the external memory
device. Data will be corrupted and the system will not work properly at the next start-up.
Be particularly careful if you use [Save to file] for [System + Scene group 0 data] because the
data to be saved will also be saved to the flash memory in the Controller at the same time.
2-8-2 Saving and Loading the Settings Data for the FH Sensor Control-
ler
• Saving Settings Data to the Controller RAM Disk or an External Memory Device in
Vision System FH/FZ5 Series User's Manual (Cat. No. Z365)
• Loading Settings Data from the Controller RAM Disk or an External Memory Device to
the Sensor Controller in Vision System FH/FZ5 Series User's Manual (Cat. No. Z365)
• Saving Settings Data to the Controller RAM Disk or an External Memory Device in
Vision System FH/FZ5 Series User's Manual (Cat. No. Z365)
• Loading Settings Data from the Controller RAM Disk or an External Memory Device to
the Sensor Controller in Vision System FH/FZ5 Series User's Manual (Cat. No. Z365)