2 Basic Operations
2 - 4
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
Design
Create the processing flow.
(1) Creating flow
Refer to 2-6 Basic Operations of Flow Editing on page 2-30
(2) Editing processing units
Refer to 4-2 Editing a Processing Unit on page 4-4
Online debugging of sensor
Perform debugging using the actual device.
(1) Performing test measurement
Perform test measurement on sample work. Adjust the parameters if necessary.
Refer to Section 6 Online Debugging
Precautions for Correct Use
The settings data for the FH sensor controller cannot be synchronized with the data in the Sys-
mac Studio project via an NJ/NX-series Controller.
Refer to 2-8 Precautions on Synchronization through an NJ/NX-series Controller on page 2-39
To synchronize them, directly connect the FH sensor controller to the computer that runs Sys-
mac Studio via Ethernet.
Refer to 3-3 Synchronizing Project Data and Sensor Setting Data on page 3-8
To Next Page
Loading...
