3 Connecting with a Vision Sensor
3 - 2
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
To establish an online connection with FH vision sensor, configure settings and make adjustments, con-
nect directly by Ethernet. You can also connect via a hub or router.
It is not possible to set and adjust FH vision sensor via NJ/NX series controller.
Precautions for Correct Use
• If there is already a different FH slave device in the project with an established online con-
nection, you will not be able to establish an online connection for a new FH slave device.
First, switch the other FH slave device from online to offline.
• Do not start the FZ/FH/FJ Simulation Tool and/or FZ_FH Remote Operation tool while using
Sysmac Studio.
• To configure account settings with an FH vision sensor, you will need to log in to your account
while online.
For details on logging in to your account, refer to 3-5 Logging in to a Registered User's
Account on page 3-12.
Ethernet
To Next Page
Loading...
