Configuration software Application
CX-Protocol The CX-Protocol is used for protocol macros with the CJ-series Serial Communications
Units.
CX-Designer The CX-Designer is used to create screens for NS-series PTs.
*1. If the NJ/NX-series Controller is a target device, you may also use Sysmac Studio version 1.10 or higher. Use the Network
Configurator if a CS/CJ-series PLC operates as the originator device.
1 Introduction to NX-series Controllers
1-9
NX-series NX502 CPU Unit Hardware User's Manual (W629)
1-1 The NX-series Controller
1
1-1-2 Introduction to the System Configurations
To Next Page
Loading...
