Omron NX Series - SD Memory Cards; Models and Specifications; Purpose

3-2
SD Memory Cards
This section describes the models, specifications, and application of the SD Memory Cards.
3-2-1
Models and Specifications
Refer to Specification of Supported SD Memory Cards, Folders, and Files in the NJ/NX-series CPU
Unit Software User’s Manual (Cat. No. W501) for details.
3-2-2
Purpose
You can use the SD Memory Card for the following applications.
• Read and write files in the SD Memory Card with instructions.
• Read and write files in the SD Memory Card from an FTP client on EtherNet/IP.
• Back up, restore, and verify data in the Controller.
• Transfer data from the SD Memory Card to the Controller when the power is turned ON.
Refer to the NJ/NX-series CPU Unit Software User’s Manual (Cat. No. W501) for details on the func-
tions for SD Memory Cards.
3 Configuration Units
3-14
NX-series NX502 CPU Unit Hardware User's Manual (W629)