Omron SYSMAC CS Series User Manual

266
How to Use the Sequence Table Block Appendix B
Actions
The following contact signals can be used for sequence table outputs.
Signal Notation on CX-
Process Tool
screen
Types Settings on CX-Process
Tool screen
Setting method Example
Output
(See note.)
OUT_H (destina-
tion): Holding contact
output operation
OUT_L (destina-
tion): Non-holding
contact output oper-
ation
OUT_P (destination):
Pulse contact output
operation
OUT_F (destina-
tion): Flashing con-
tact output operation
Function block
contact output
item
Output tab destination
specification: Block ITEM
Select the block ITEM
and select the ITEM
number from the
detailed information.
For block
address 001
and ITEM
086: 001.086
CSV tag and tag
ITEM
(Contact output
ITEM for control
and operation
blocks)
Output tab destination
specification: Tag No.
Select the ITEM tag
and select the tag
ITEM from the detailed
information.
For the A/M
switch for the
Master01
CSV tag:
Master01.A_
M
User link table
name (I/O mem-
ory in CPU Unit)
Output tab destination
specification: User link
table
Select the block ITEM
and select the ITEM
number from the
detailed information.
For Value1
user link
table tag:
LNK007:Valu
e01
Timer/counter
reset start, opera-
tion start/stop,
and pause com-
mands
Output tab destination
specification: Element
action (destination)
Select the area type
and select the link
table tag name from
the detailed informa-
tion.
---
Table Com-
mand
STEP(sequence
table block address,
step number)
Setting of a spe-
cific step in
another sequence
table
Table Command Tab com-
mand classification:
STEP(block address, step
number)
Block address and
step number
For block
address 702,
step 03:
70203
RUN(sequence table
block address)
Starting another
sequence table
Table Command Tab com-
mand classification:
RUN(block address)
Block address For block
address 702:
702
STOP(sequence
table block address)
Stopping another
sequence table
Table Command Tab com-
mand classification:
STOP(block address)
Block address For block
address 702:
702
Write to
ITEM
SET(value, destina-
tion)
Writing a con-
stant to a function
block ITEM write
parameter
Write to ITEM tab destina-
tion: Block ITEM
Select the block ITEM,
select the ITEM num-
ber from the detailed
information, and input
the write data (-32,000
to 32,000).
---
Writing a con-
stant to an CSV
tag and tag ITEM
(Contact output
ITEM for control
and operation
blocks)
Write to ITEM tab destina-
tion: Tag No.
Select the ITEM tag,
select the tag ITEM
from the detailed infor-
mation, and input the
write data (-32,000 to
32,000).
---
User link table
(writing a constant
to I/O memory in
the CPU Unit)
Write to ITEM tab destina-
tion: User link table
Select the area type,
select the user link
table tag from the
detailed information,
and input the write
data (-32,000 to
32,000: Input the
scaled value for the
user link table).
---

Omron SYSMAC CS Series Specifications

General

Brand	Omron
Model	SYSMAC CS Series
Category	Controller
Language	English