Omron SYSMAC CS1 User Manual

6-4SectionAR Area
87
Address Forced
set/reset
Controlled
by
DetailsFunctionBits
AR 17
00 Analog Output 1
User Adjustment
Flag
The default setting is OFF. When offset/gain
adjustment is performed by the user, these
bits turn ON, and when the adjustment
llddttthift
Unit Enabled
01 Analog Output 2
User Adjustment
Flag
,j
values are cleared and reset to their factory
settings these bits return to OFF.
02 to 03 (Reserved by system.)
04 Analog Output 1
Operation In
Progress
ON: Analog output is being changed using
the ACC instruction.
OFF:
A
n
a
log o t
p
th
a
sre
a
ched the t
a
rget
05 Analog Output 2
Operation In
Progress
OFF:
An
a
log
o
u
t
u
t
h
a
s
re
a
ched
the
t
a
rget
value.
06 to 07 (Reserved by system.)
08 Analog Output 1
Output SV Error
ON: A value that exceeds the allowable
range has been set for analog output SV.
OFF: The values set for analog output SV
09 Analog Output 2
Output SV Error
OFF:
The
val
u
es
set
for
analog
o
u
t
u
t
V
lie within the allowable range.
Note: This bit is valid only when the analog
output method is set to END refresh.
10 to 11 (Reserved by system.)
12 Analog Output 1
Factory Setting
Adjustment Error
ON: There is an error in the factory-set data
stored in FROM.
OFF: There
a
re no errors in the f
a
ctory
-
set
13 Analog Output 2
Factory Setting
Adjustment Error
OFF:
There
a
re
no
errors
in
the
f
a
ctory
-
set
data stored in FROM.
14 Analog Output 1
User Adjustment
Error
ON: There is an error in a user adjustment
value stored in FROM.
OFF: There
a
re no errors in the ser
15 Analog Output 2
User Adjustment
Error
OFF:
There
a
re
no
errors
in
the
u
ser
adjustment values stored in FROM.

Omron SYSMAC CS1 Specifications

General

Brand	Omron
Model	SYSMAC CS1
Category	Controller
Language	English