Section 6 Operation Interface
Configuration File
This section describes the format of the configuration file. The configuration file uses a normal INI file
format.
Any line that starts with a semicolon (;) is treated as a comment.
Any line that starts with an opening bracket ([) is treated as a section declaration row. The row must
also end in a closing bracket (]).
Any row that does not start with either of the above two characters is an entry row.
Section and Entry Table
Section name Entry name Description Default
NetworkSetting IPAddress Gives the setting of the IP address of the
Reader/Writer. Specify four decimal numbers
separated by periods.
192.168.1.200
SubnetMask Gives the setting of the subnet mask of the
Reader/Writer. Specify four decimal numbers
separated by periods.
255.255.255.0
GatewayAddress Gives the setting of the default gateway of
the Reader/Writer. Specify four decimal
numbers separated by periods.
192.168.1.254
BOOTPOption Gives the setting of the Reader/Writer
BOOTP option. Specify a decimal value.
0: Fixed settings
1: Get from BOOTP server
2: Get from BOOTP server as fixed settings
0
DeviceName Gives the name of the Reader/Writer.
Specify up to 63 ASCII characters.
WebPassword Gives the login password for the browser
interface. Specify up to 15 ASCII characters.
Specify ““ (blank) for no password.
WebPortNo Gives the Ethernet communications port
number for the browser interface. Specify
1024 to 65535 decimal.
7090
RFTagCommunicationSetting CommunicationSpe
ed
Gives the communications speed between
the Reader/Writer and RF Tags. Set a
decimal number.
0: High speed
1: Normal speed
0
WriteVerify Gives the setting for write verification for
write communications. Set a decimal
number.
0: No verification
1: Verification
1
CommunicationOpti
on
Gives the setting of the RF Tag
communications option. Set a decimal
number.
0: Once
1: Repeat
2: FIFO Repeat
0
To Next Page
Loading...
Need help?
General
