Safety Instructions
S-4
■
Warning label 3
WARNING
Improper installation or operation may cause serious injury.
Before installing or operating the robot, read the manual and instructions on the warning labels and understand
the contents.
Instructions on this label
• Be sure to read the warning label and this manual
carefully to make you completely understand the
contents before attempting installation and operation
of the robot.
• Before starting the robot operation, even after you
have read through this manual, read again the
corresponding procedures and "Safety Instructions".
• Never install, adjust, inspect or service the robot in
any manner that does not comply with the
instructions in this manual.
Potential hazard to human body
Improper installation or operation may cause serious injury.
To avoid hazard
Before installing or operating the robot, read the manual and instructions on the
warning labels and understand the contents.
90K41-001290
■
Warning label 4
CAUTION
Do not remove the parts on which Warning label 4 is attached.
Doing so may damage the ball screw.
Instructions on this label
The Z-axis ball screw will be damaged if the upper end
mechanical stopper on the Z-axis spline is removed or
moved. Never attempt to remove or move it.
90K41-001520
To Next Page
Loading...
