A
Troubleshooting
A-14
3.206 : Too many breakpoints
Code : &H0003 &H00CE
Meaning/Cause
More than 32 break points were set.
Action
Delete unnecessary programs and then set new ones.
(32 or less break points can be set per program.)
3.207 : Breakpoint doesn't exist
Code : &H0003 &H00CF
Meaning/Cause
The break point was not found during search.
Action
Set break points if necessary.
3.208 : Current program doesn't exist
Code : &H0003 &H00D0
Meaning/Cause
The current program is not registered.
Action
Set the current program on "Current program no." of the controller parameter.
3.218 : Duplicated Breakpoint
Code : &H0003 &H00DA
Meaning/Cause
Break points were already set on the line.
Action
−−−
3.219 : Illegal program no
Code : &H0003 &H00DB
Meaning/Cause
A program number exceeding 1 to 100 was set.
Action
Specify a program number between 1 and 100.
3.220 : Program step doesn't exist
Code : &H0003 &H00DC
Meaning/Cause
The number of lines exceeding the number registered in the program was specified.
Action
Specify lines registered in the program.
3.221 : Reading prohibited
Code : &H0003 &H00DD
Meaning/Cause
The program with the hidden attribute was browsed.
Action
Make the relevant program readable.
3.237 : Program has been already loaded
Code : &H0003 &H00ED
Meaning/Cause
The program that is already in the executable status was loaded.
Action
−−−
To Next Page
Loading...
