Omron ZN-CTX21 - Configuration; Standalone; Network Connection; Remote Setting and Operation from PC

1. Product Overview
1-3
1.2 Configuration
This product can be used in the following two types of configuration.
1.2.1 Standalone
Portable Power Monitors can be operated standalone without connecting them to a network.
The measured data is recorded in the internal memory and can be loaded to a PC via an SD
card. The recorded data in an SD card can be displayed in graphs using SD Viewer ES or
Energy Viewer, software included in Station Utility. (Refer to "Station Utility User's Manual" for
the PC software details.)
1.2.2 Network Connection
Portable Power Monitors can be connected to a PC via LAN. The following operations are
available by using the PC software. (Refer to "Station Utility User's Manual" for the PC
software details.)
(1) Remote Setting and Operation from PC
Settings on Portable Power Monitors (except for IP address settings) and recording start/stop
operation can be controlled remotely from the PC by using the Station Utility (PC software)
setting tool.
(2) Measured Data Acquisition to PC
The measured data on Portable Power Monitors can be acquired to the PC using the Station
Utility (PC software) logging tool. The acquired data can be displayed in graphs offline on SD
Viewer ES or Energy Viewer included in Station Utility.
Standalone
Network Connection
HUB
PC
LAN Cable